Erowid
 
 
Plants - Drugs Mind - Spirit Freedom - Law Arts - Culture Library  

#45 2C-T-9

2,5-DIMETHOXY-4-(t)-BUTYLTHIOPHENETHYLAMINE


[3D .mol structure]
SYNTHESIS: To a well-stirred ice-cold suspension of 2.8 g p-dimethoxybenzene and 3.2 mL N,N,N',N'-tetramethylethylenediamine in 100 mL petroleum ether under an inert atmosphere of He, there was added 13 mL of a 1.6 N solution of butyllithium in hexane. The suspended dimethoxybenzene became opaque and there was a pale yellow color generated. The reaction mixture was warmed to room temperature which converted it to light white solids. After an additional 0.5 h stirring, there was added, slowly, 3.6 g of di-(t)-butyldisulfide. The yellow color deepened, the solids dissolved and, after 1 h, the color was a clear deep brown. This solution was poured into 100 mL dilute HCl and the organic phase was separated. The aqueous fraction was extracted with 3x75 mL CH2Cl2. The combined organic phases were washed with dilute aqueous NaOH, with H2O, and then stripped of solvents under vacuum. The residue was distilled at 95-105 °C at 0.5 mm/Hg to provide 3.7 g of 2,5-dimethoxyphenyl (t)-butyl sulfide as a white, mobile liquid. Anal. (C12H18O2S) C,H. A solid derivative was found in the nitration product, 2,5-dimethoxy-4-(t)-butylthio-1-nitrobenzene, which came from the addition of 0.11 mL of concentrated HNO3 to a solution of 0.23 g of the above sulfide in 5 mL ice cold acetic acid. Dilution with H2O provided yellow solids which, on recrystallization from MeOH, had a mp of 92-93 °C. Anal. (C12H17NO4S) C,H. Attempts to make either the picrate salt or the sulfonamide derivative were not satisfactory.

A mixture of 72 g POCl3 and 67 g N-methylformanilide was heated for 10 min on the steam bath. To this claret-colored solution was added 28 g of 2,5-dimethoxyphenyl (t)-butyl sulfide, and the mixture heated for 10 min on the steam bath. This was then added to 1 L of H2O and stirred overnight. The residual brown oil was separated from the water mechanically, and treated with 150 mL boiling hexane. The hexane solution was decanted from some insoluble tars, and on cooling deposited a dark oil which did not crystallize. The remaining hexane was removed under vacuum and the residue combined with the above hexane-insoluble dark oil, and all distilled at 0.2 mm/Hg. An early fraction (70-110 °C) was largely N-methyl-formanilide and was discarded. Crude 2,5-dimethoxy-4-(t-butylthio)benzaldehyde came over at 120-130 °C and weighed 12.0 g. This was never satisfactorily crystallized despite the successful formation of seed. It was a complex mixture by TLC, containing several components. It was used for the next step as the crude distilled fraction.

To a solution of 10 g impure 2,5-dimethoxy-(t-butylthio)benzaldehyde in 75 mL of nitromethane there was added 1.0 g of anhydrous ammonium acetate, and the mixture was heated on the steam bath 1.5 h. Removal of the excess solvent/reagent under vacuum produced an orange oil that was (not surprisingly) complex by TLC and which would not crystallize. A hot hexane solution of this oil was allowed to slowly cool and stand at room temperature for several days, yielding a mixture of yellow crystals and a brown viscous syrup. The solids were separated and recrystallized from 40 mL MeOH to give 3.7 g 2,5-dimethoxy-4-(t)-butylthio-beta-nitrostyrene as fine lemon-yellow crystals, with a mp of 93-94 °C. A second crop of 1.4 g had a mp of 91-92 °C. Anal. (C14H19NO4S) C,H.

A solution of LAH (70 mL of a 1 M solution in THF) was cooled, under He, to 0 °C with an external ice bath. With good stirring there was added 2.1 mL 100% H2SO4 dropwise, over the course of 20 min. This was followed by the addition of 4.7 g 2,5-dimethoxy-4-(t)-butylthio-beta-nitrostyrene in 20 mL anhydrous THF. There was an immediate loss of color. After a few min further stirring, the mixture was allowed to come to room temperature, and the stirring was continued for 5 h. The excess hydride was destroyed by the cautious addition of 10 mL IPA followed by 6 mL 15% NaOH and finally 6 mL H2O. The loose white solids were removed by filtration, and the filter cake washed with THF. The filtrate and washes were combined and, after stripping off the solvent under vacuum, there was obtained 4.66 g of a pale yellow oil. Without any further purification, this was distilled at 0.2 mm/Hg. A first fraction came over at up to 120 °C and was a light colorless oil that was not identified. The correct product distilled at 130-160 °C as a pale yellow viscous oil that weighed 1.66 g. This was dissolved in 10 mL IPA, neutralized with 20 drops of concentrated HCl and diluted with 80 mL anhydrous Et2O. After standing a few min there was the spontaneous generation of white crystals of 2,5-dimethoxy-4-(t)-butylthiophenethylamine hydrochloride (2C-T-9) which were removed by filtration, and air dried. The weight was 1.10 g.

DOSAGE: 60 - 100 mg.

DURATION: 12 - 18 h.

QUALITATIVE COMMENTS: (with 90 mg) 2C-T-9 tastes the way that old crank-case motor oil smells. I was up to something above a plus two at the third hour. Although there were no visuals noted, I certainly would not choose to drive. Somehow this does more to the body than to the head. I feel that the effects are waning at maybe the sixth hour, but there is a very strong body memory that makes sleeping difficult. Finally, at sometime after midnight and with the help of a glass of wine, some sleep.

(with 125 mg) There was a steady climb to a +++ over the first couple of hours. So far, the body has been quite peaceful without any strong energy push or stomach problems, although my tummy insists on being treated with quiet respect, perhaps out of habit, perhaps not. At the fifth hour, the body energy is quite strong, and I have the choice of focusing it into some activity, such as love-making or writing, or having to deal with tapping toes and floor-pacing. For a novice this would be a murderously difficult experience. Too much energy, too long a time. I suppose I could get used to it, but let me judge by when I get to sleep, and just what kind of sleep it is. It turned out that sleep was OK, but for the next couple of days there was a continuing awareness of some residue in the body--some kind of low-level poisoning. I feel in general that there is not the excitement or creativity to connect with, certainly not enough to justify the cost to the body.

EXTENSIONS AND COMMENTARY: The three-carbon analog of 2C-T-9 (this would be one of the ALEPH series) has never been made and, for that matter, none of the higher numbered 2C-T's have had the amphetamine counterparts synthesized. They are, as of the present time, unknown compounds. This nifty reaction with di-(t)-butyl disulfide worked so well, that three additional disulfides that were at hand were immediately thrown into the chemical program, with the quick assignment of the names 2C-T-10, 2C-T-11, and 2C-T-12.

The lithiated dimethoxybenzene reaction with 2,2-dipyridyl disulfide produced 2,5-dimethoxyphenyl 2-pyridyl sulfide which distilled at 135-150 °C at 0.4 mm/Hg and could be recrystallized from cyclohexane containing 2% EtOH to give a product that melted at 66-67.5 °C. Anal. (C13H13NO2S) C,H. This would have produced 2,5-dimethoxy-4-(2-pyridylthio)phenethylamine (2C-T-10) but it was never pursued.

The same reaction with di-(4-bromophenyl) disulfide produced 2,5-dimethoxyphenyl 4-bromophenyl sulfide which distilled at 150-170 °C at 0.5 mm/Hg and could be recrystallized from MeOH to give a product that melted at 72-73 °C. Anal. (C14H13BrO2S) C,H. This was being directed towards 2,5-dimethoxy-4-(4-bromophenylthio)phenethylamine (2C-T-11) but it also was abandoned.

The same reaction with N,N-dimorpholinyl disulfide produced virtually no product at all, completely defusing any plans for the synthesis of a novel sulfur-nitrogen bonded base 2,5-dimethoxy-4-(1-morpholinothio)phenethylamine (2C-T-12). One additional effort was made to prepare a 2C-T-X thing with a sulfur-nitrogen bond. The acid chloride intermediate in the preparation of 2,5-dimethoxythiophenol (as described in the recipe for 2C-T-2) is 2,5-dimethoxybenzenesulfonyl chloride. It reacted smoothly with an excess of diethylamine to produce 2,5-dimethoxy-N,N-diethylbenzenesulfonamide which distilled at 155 °C at 0.13 mm/Hg and which could be recrystallized from a 4:1 mixture of cyclohexane/benzene to give a product with a melting point of 41-42 °C and an excellent proton NMR. This amide proved totally refractory to all efforts at reduction, so the target compound, 2,5-dimethoxy-4-diethylaminothiophenethylamine, has not been made. It has not even been given a 2C-T-X number.


[ Back] [Main Index] [Forward ]
Back Main Index TiHKAL Forward